Hand Tools

Subject:
Bevel prep?
Response To:
Exactly... ()

Derek Cohen (in Perth, Australia)
David, are you honing a full bevel, secondary micro bevel, or micro bevel on a hollow grind?

I would recommend a hollow grind to reduce the amount of steel to a minimum. This will enable some non-diamond media on 3V (such as Spyderco), as well as most media on PM-V11.

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081