Hand Tools

Subject:
Re: Float Question
Response To:
Re: Float Question ()

William Duffield
Sorry, Steve. I misspoke, due to lack of familiarity with the terminology. I'm making an edge float, not a side float. I'm going to attempt to cut the teeth with a dovetail end mill, if I can figure out how to set up the milling operation. I don't have the machine (e.g., a Bridgeport) that I should mount the end mill on, so I'm working on a kludge. I'll report back if I can make it work.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081