Classifieds

Subject:
General 260 Lathe

John Morand
>I have a general 260 1hp lathe with 20" swing inboard and 24 outboard. Comes with 4 inch face plate, 6 inch faceplate. I have just taken delivery on a new lathe and the shop is small. I am located east of Toronto Ontario. I am asking $2800 for this great lathe. I bought it five years ago from an estate auction and it had been seldom used by a retired executive. The lathe was upgraded with a riser block and the appropriate banjo alterations. A 2hp motor can be added at any time. The lathe is variable speed on a single pulley system with ten setiings from about 190 rpm to 2800 rpm.

John Morand

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081