Classifieds

Subject:
Re: OneWay coring system
Response To:
Re: OneWay coring system ()

Mark Paulley
I used it on my Woodfast with a 10" swing. From what I understand the base is the same for all large lathes the metal spacers in the bottom are adjusted in height. It will fit the out board side of the 1640
You are correct on the knife sizes

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081