Classifieds

Subject:
Re: Is it for the 1640?
Response To:
Is it for the 1640? *NM* ()

Mark Paulley
I used it on my Woodfast with a 10" swing. From what I understand the base is the same for all large lathes the metal spacers in the bottom are adjusted in height. It will fit the out board side of the 1640

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081