Turning Archive 2006

Subject:
Floor stands for banjos/tool rests

Chris K in MD
>I was wondering if there are any of you out there that have experiance with stands to turn off board of your lathe and satandard banjo setup. Powermatic offers one for 3520A, I think the lower set of holes to mount the 18" bed on the 3520B renders this item not likely required. I Have seen some pictures of people with thier outboard stands, but dont know where they bought them and If there pleased with them. Thank you for any info that you have.

Regards,

Chris

Messages In This Thread

Floor stands for banjos/tool rests
Re: Floor stands for banjos/tool rests
Re: Floor stands for banjos/tool rests
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081