Turning Archive 2006

Subject:
FYI, Vicmarc VM100 w/ Grizzly Pin jaws. *PIC*

Eddie Pacheco; San Jose, Ca.
>I just received a set of the 1" Pin Jaws (H6268), from Grizzly, and installed them on my VM-100. The jaws fit nicely and I have to say that they are deburred better than other Vicmarc pieces I have purchased. For $18.95 I think these will work well for me.
I also purchased a MT-2 Live Center (H3408) for $10.95 and when turned by hand you can feel a bit of a "flat" spot in the bearings. The bearings may have gotten tapped into place during assembly. I'm curious to see how this item works out under load.

Messages In This Thread

FYI, Vicmarc VM100 w/ Grizzly Pin jaws. *PIC*
Re: FYI, Vicmarc VM100 w/ Grizzly Pin jaws.
Re: FYI, Vicmarc VM100 w/ Grizzly Pin jaws.
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081