Turning Archive 2006

Subject:
diagonal/cross section views of platters

Jeremy
>Hello all,
Simple question - do you know of any web site that has side views and/or drawings of platters/plates. I can find loads for bowls, but hardly any for platters. Perhaps it is because this is just too simple but I would like to see some ideas/plans/drawings of the cross-section of plates/platters.
thanks for your time,
jeremy

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081