Turning Archive 2006

Subject:
Oneway Talon Set Screw *LINK*

Craig Daymon
>I want to order up some soft tip set screws for my Talon chuck. I know it is an 8mm set screw, but McMaster-Carr has many additional qualifiers such as length, metric thread pitch, thread size (M8?), so does anyone have a good sense of what I should use/select?

Link to the soft tip page where I stopped qualifying below. Hopefully it will take you there as I think some of their page is dynamically construct.

Thanks,
Craig

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081