Turning Archive 2005

Subject:
? Baldor Grinders & Wolverine Jigs

Jim J. in TX
>I have a very nice smooth running 8" Baldor slow speed grinder, that I would like to use with a Wolverine Jig. The problem is that the cast iron wheel guards project way lower than the recommended 6.25" recquired for the jig. I am sure that another turner has encountered this problem before, and would like to hear how they successfully adapted the setup. I have done a search of the archives - to no avail. Many Thanks to those who have previously shared their knowledge on this board, making it a wonderful resource.
All the Best for the New Year. Jim J.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081