Turning Archive 2005

Subject:
Christmas Projects... *PIC*

DWR
>This is a follow-up to the 12" saga from the main message board.

Here are the spindles that were cut on the modified jig, rather than swapping in a 12" blade.

I still need to finish machining the bases and tops, but one is done and the rest will be finished tomorrow.

They will hold both a pillar and a taper candle... Each is turned a little differently and the tops and bases are Walnut, Cherry and Curly Maple. The spindles are European Beech.

Thanks for all the advise from the main board...

Dave

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081