Turning Archive 2005

Subject:
Turning Topic for 12/21/05 is...........

TD
>Hollowing tools, methods, tips, etc. If you are just beginning to hollow you should limit the shapes you try until you know what tools to use and how to use them. You should know the difference between end-grain hollowing and cross-grain. Different shapes and opening sizes require different tools. Hogging out is done with different cutters than the final finishing cuts. Join us at 9:00pm Wed night for some good tips on getting started hollowing. As always, general turning conversation from 9 to 9:30 and we'll start the topic at 9:30pm eastern time. The topic runs for one hour and then we go back to general turning conversation. No greetings or good-bye's during the topic hour please. Also, remember to use the "private" button for one on one conversations. Thanks all.
TD

Messages In This Thread

Turning Topic for 12/21/05 is...........
Sounds like a winner. Still trial and error here. *NM*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081