Turning Archive 2005

Subject:
Rolling Pins

Matt Birchfield
>Hi Group,

Has anybody turned functional rolling pins with a metal axle shaft through the middle? If so, what did you use for bearings?

I was thinking of using UHMW plastic inserts in the body for the bearing surfaces rather than messing with ball-bearings of any sort.

Any experiences or thoughts to share?

Matt

Messages In This Thread

Rolling Pins
Re: Rolling Pins
Re: Rolling Pins
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081