Turning Archive 2005

Subject:
Calling Darryl Hansen

MFoster
>I just sanding a bowl with my sioux drill and the rear bearing died. I've had it quite a while, so am not complaining. I have the old model with the switch on the back. I took it apart, and sure enough, it was the rear bearing. How did you remove the old bearing? I'm going to call Boca for a new one (I remembered the recent post and assume you have done this from your message). Thanks in advance.

Mike

Messages In This Thread

Calling Darryl Hansen
Re: Calling Darryl Hansen
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081