Turning Archive 2005

Subject:
Turning tool sharpening

Mike Mullen
>I posted this question in the general area of the message board and again here. I need some advice on which way to go for sharpening lathe tools. I have been looking at the Delta Industrial model 23-710 Sharpening Center. Is this a good machine? Or should I go for a jig on my grinder? Thanks, Mike

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081