Turning Archive 2005

Subject:
Glaser 3/4" Gouge Question

George Van in WI
>I was looking at 3/4" bowl gouges. Does anyone have experience with the new 3/4" Glaser gouge? I understand the flute to be only 5", that seems really short. I have never used one. I was also told the 5" tip is V-15 steel, adhesive attached to the shaft. I have always heard nothing but good for the Glaser gouges but this one brings up a question. Thanks for the advice.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081