Turning Archive 2005

Subject:
I can't read...

albertabob
>Ray Allens book edited by Dale Nish.It's called Woodturning with Ray Allen published by Fox chapel Publishing.
I'm trying to figure out the width of the feature ring as described on page 15 being 10.05" across and each segment being 2.012"
The the author goes on to show the ring with 16 more dividing strips of .125" in between the diamonds.
So what should the measurement be for each segment?

2.012 + 1.25?

I have been struggling with this book for weeks.
Somebody should proof read it before they reprint it agian .
It's really hard to read.

Bob

Messages In This Thread

I can't read...
Re: I can't read...
Re: I can't read...
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081