Turning Archive 2005

Subject:
Bandsaw lighting solution *PIC*

Dave Shombert
>I use my bandsaw a lot, mostly for precision cutting. So I gotta be able to see my layout lines clearly. I had one of those "machine accessory" lights for years, but it seemed like it was always in the way. If it was providing light where I wanted it, then it was in a place where I'd bump my head against it in the middle of the cut. Plus, it was hot. Then I found this little guy at a Lowe's, and it's perfect. One of the many Dremel accessories. CLip it on the guide post and you can shine the light right on the cut, it's out of the way, and there's no heat. Its only drawback is that I keep forgetting to turn it off when I'm done. But I'll learn that habit eventually. So useful I just had to share it.

Dave Shombert
Elkins, WV

Messages In This Thread

Bandsaw lighting solution *PIC*
Re: Bandsaw lighting solution
Re: Bandsaw lighting solution
Re: Bandsaw lighting solution
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081