Turning Archive 2005

Subject:
need vacuum chuck for Jet 1642

dick mc neill
>I know this thread was discussed recently but I can't find it on this site's search engine. I have just bought a Jet 1642. Is there a complete vacuum system that would fit that lathe with minimum set up (I'd rather turn then put together a home made vacuum chuck). I'm intrigued by the fact that the lathe's headstock handwheel is in fact a cylinder engineered for a vacuum chuck. Any & all advice is welcomed & appreciated.

Messages In This Thread

need vacuum chuck for Jet 1642
Re: need vacuum chuck for Jet 1642 *LINK*
Packard Woodworks, Oneway
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081