Turning Archive 2005

Subject:
faceplate screw advice please

ken chase
>After problems with phillips head screws I want to use only square head
and need advice where to get them and what type to use. I currently only have a three inch plate. A problem has been the need to use a long drill bit because the short bit causes the drill to get in the way and not allow a straight hole. I bought hex head screws but couldn't use them for the same reason. Are there hex drivers with a long shaft?
Thanks

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081