Turning Archive 2005

Subject:
seg bowl diamonds

gary clarke
>What is the best way to make diamonds for including in segmented bowls? I have tried several methods including: router, disk sanding, and sawing squares in half, and I am not satisified with the results.There always is a small asymmetry or a poor glue joint or a poor router joint, etc. Maybe I need to do a couple of dozen or so before they turn out. thanks for any suggestions.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081