Turning Archive 2005

Subject:
Midi Hollowmaster

Vicmarc.fan
>UPS just delivered a new tool this morning. I have the Sorby Multi-tip but it dosent have the swan neck shape. This tool seems to be a fine chatter tool but not much good for hollowing. I remember reading something about left ot right side for the cutter but dont remember for sure what was recommended. It comes with the cutter on the left and the instructions show on the left but it didnt work that way for me so I switched to the right and could see no didderence, still bad. Any ideas?

Ron

Messages In This Thread

Midi Hollowmaster
Re: Midi Hollowmaster
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081