Turning Archive 2005

Subject:
Service from Brian @ Craft Supplies

Larry
>Just a quick post to draw attention to some wonderful service from Brian at Craft Supplies. I had a problem with the backing plate on an Axminster chuck being too thin to seat on my Nova 3K. Brian immediatly sent me some nylon spacers to use till he could get a replacement from Axminster. That turned out to be easier said than done. However, due to Brian's persistance Axminster finally came through. I really appreciate his effort.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081