Turning Archive 2005

Subject:
Wally, don't you....

W.C. Turner
>begin your turnings, using the screw center, with tail stock for support. Then apply the glue block while the blank is still on the lathe, or off, this is where it gets fuzzy.......

If I'm incorrect here, could you fill in the blanks on your procedure?

Thanks,
W.C.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081