Turning Archive 2005

Subject:
Jaw sets for a Talon?

Ed Kelle
>I thought I had read somewhere about some other manufacturer's jaws fitting a Talon but I just can't remember. Right now I have the Talon sets, but I'd really like to get one that would fit a 1" tenon or so. The spigot ones do fit it but really are close to the far end of their range and will crush it a little, while the standard ones don't go below about 1 3/4" or so.

anyone have other suggestions for me? thanks!

Messages In This Thread

Jaw sets for a Talon?
Re: Jaw sets for a Talon?
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081