Turning Archive 2005

Subject:
Help w/McNaughton and Powermatic 3520

Frank Martin
>Just got my new McNaughton system and was all set to do my first core when I realized that the standard tool post is too short (by about an inch)for my Powermatic 3520. Looked at Kelton site and the catalog suppliers and no mention of alternate tool posts although they must exist. Anyone running this combination who can point me in the right direction for a solution??

thanks, frank

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081