Turning Archive 2005

Subject:
Lathe Spindle Morse Taper Scoring

Roland B. Kuehn
>This the second posting of this message, the first was on the general message board, but my son advised me to post it on the turning message board so here it is. I have a new 3520A Powermatic lathe that now has a scored internal Morse #2 Taper from a drive center that evidently turned in it. It took a bit to drive the center out. What is the best way to clean up this score? Thanks to those who answered my posting on the general message board.

Bo

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081