Turning Archive 2005

Subject:
Yates American J-170 lathe

Kudzu
>I am looking for some info on this lathe. I think I read where you had one Ellis? Specifically I am looking for it's lowest (variable) speed is and if the head is built so that I could add a riser block.

Any answers or other information on this lathe would be very welcome!!

Messages In This Thread

Yates American J-170 lathe
Re: Yates American J-170 lathe
Also known as a J-Line Lathe *NM*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081