Turning Archive 2005

Subject:
VB36 floor fixing

Michael Sinclair
>Hello all,
bit of a gloat and aquestion for any VB owners out there.
I have had my VB for just over a month now but only had a chance to play on it this last 2 weeks.
How tight down do you bolt the lathe.I have tried it with the bolts just nipped up and tightened right up with a T bar but to be honest there was not much difference.Just wondering if I should torque it right up when and if it gets loaded with a big blank.
Too late to phone VB tonight, but will give them a call in the morning
Thanks for any thoughts.
Michael

Messages In This Thread

VB36 floor fixing
Re: VB36 floor fixing
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081