Turning Archive 2005

Subject:
How to tell morse taper on delta lathe?

Bruce, a MN Galoot
>I have an old Delta Dual Duty lathe, dating probably from the 1930's or so, procured the old-fashioned way: I inherited it from my grandfather.

Anyway, I would like to get a live center for the tailstock but I don't know how to determine which Morse taper it requires. How do I tell?

Thanks

Bruce

Messages In This Thread

How to tell morse taper on delta lathe?
Thanks, guys,
Re: How to tell morse taper on delta lathe?
Re: How to tell morse taper on delta lathe?
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081