Turning Archive 2005

Subject:
#2MT Forster bits

Terry Daniel
>I have been searching for a source of 2 to 3 inch diameter Forster bits with a Morse taper shaft and an over-all length of 16". I have not found a source on one ready made but I have found a company that will make them. I'll have to have a rather large number made to get the cost reasonable. Anyone else interested in these?
TD

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081