Turning Archive 2005

Subject:
Got one of these you're not using?

David
>Not a lathe tool, but a drill chuck. I'm looking for a Black & Decker drill chuck 64576-01, which is a screw-on variety (has a screw sticking out the back). Is is also marked "0 - 1/4 CAP., 3/8 - 24 THD." It is a keyed chuck.

If you've got one, chances are pretty good that you'll have to blow the dust off it to check the numbers. I don't think it will enable you to retire, but I'd be happy to buy it from you.

Mine has a bent screw, and it is a pretty complex bend to successfully straighten it. I'm having a time finding a replacement because it is too old.

Thanks -
David B.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081