Turning Archive 2005

Subject:
Question for Don Pencil Stinger owners

Carole in VA
>Shouldn't the set screw that holds the bit in the shank for angled boring bar and the curved bar be on TOP of the tool 1)so the shank can be held flat against the grinder rest for shaping and 2) so that tiny screw doesn't fall out into the shavings if it vibrates loose? It looks like it is in the "manual", but it's not the case with mine.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081