Turning Archive 2005

Subject:
? for Dominic

Mike Schwing from Md.
>Dominic, I was looking at the article you wrote on the shopmade texturing tool, in prep for doing the same, and had a question.

You make mention of receiving the 6mm cutter and not the texturing cutter, and that you would be getting that one later on.

My question was three parts - have you received that second cutter, what is the difference, and if you had to choose one - which?

Thanks bud.

Messages In This Thread

? for Dominic
Hi Mike! *PIC*
Re: Hi Mike!
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081