Turning Archive 2005

Subject:
Swing on lathe

Andrew Frank
>Hey just basic question... If i was to buy a lathe with a 10 inch swing, does this mean that from the center of the lathe chuck, it is 10'' from the rails that the tail stock slides on? or does it work like the drill press idea, and only 5'' from center to weighs. Thanks

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081