Turning Archive 2005

Subject:
Silver Solder Question #2

Spence in Rhode Island
>Whats the best joint to use when soldering tool bits to the shaft? Half lap? Butt joint? Dovetail?? LOL I'm using a round 5/16" HSS tool bit and attaching it (I hope!) to 5/16" Cold rolled steel rod. To be used for small hollow forms like Christmas ornaments.
Thanks again
Spence

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081