Turning Archive 2005

Subject:
How can I hold......

Spence in Rhode Island
>A semi round hollow form so I can finish the bottom?? It's collared with a 3/8" opening. Haven't parted it off the glue block yet but put the last or next to last coat of finish on the body. I know I can hand sand it but was wondering if anyone had an idea on how to do it on the lathe. Was thinking of some kind of jam chuck but I'm worried about screwing up a very high gloss finish.

LOL This is typical back asswards situation for me. I'm the kind of guy who always reads the directions AFTER I put something together.
TIA
Spence

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081