Turning Archive 2005

Subject:
3520A outboard spindle thread?

Chris K. in MD
>I am looking for the thread on the outboard spindle to setup my lathe fro vacuum chucking. No where on the WMH site or in my manual does it call out what the thread is, its a pretty fine pitch. Does anyone know? TIA

Chris

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081