Turning Archive 2005

Subject:
Jet Mini Help Update...

Bert Smith
>I went to look at the lathe during my lunch hour. I bypassed the switch and the motor ran fine. Switch problem! Took the switch apart, cleaned it and everything now works. I noticed this switch is different than the switched on my older Mini's.
Since this is a new lathe, and the fact that this fellow recently joined our chapter, should I give him a club discount for my services???...:-)
I'm just glad it wasn't the motor. Thanks for the suggestions!
Bert

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081