Turning Archive 2005

Subject:
face plate question

ken chase
>The 4 jaw chuck I have on order hasn't arrived. I turned the exterior of a small piece and mounted the reverse to a faceplate to hollow the center. The darn thing just would not turn smoothly. I'm thinking it has to be dead center. Is that right?
Or is there another possible cause.
Thanks
Ken Chase (a beginner)

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081