Turning Archive 2005

Subject:
Separating a hot-glued turning

Mainebowlman
>After finish turning the bottom of a piece, I'd like to reverse it and hot glue it to a waste blank. Later on, however, I want to be able to remove it from the waste blank without using a parting tool.

Has anyone found a solvent or a procedure to separate a hot-glued turning from the blank?

Jack (in the Mud)

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081