Turning Archive 2005

Subject:
How to attach tips.

Don Henthorn
>I made a curved hollowing tool today because I am making a smaller hollow form than my Laser rig can handle. I am using a short piece of 3/16" tool bit for the tip. I was going to braze it on the drill rod but rememberd that some of you glue them on with cyanocrylic. I may try that but first I wondered if anyone had ever had trouble with the heat of turning causing the glue to let go. Thanks for your experience.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081