Turning Archive 2005

Subject:
A suprise I got

ben d.
>Just got my Super Nova Chuck out of the box to turn a bowl and it was fine, much better than the past method's I had been using. Now the suprise, also got a set of cole jaws and was going to install them on the chuck, no problem but I had turned a I think now 7 5/8" bowl on the outside dia. and believe it or not no position of the rubber buttons mounted on the jaws would chuck the bowl. What a downer inside of the bowl was curved so that did not work well either although I did use in that manner to half A turn the bottom. Should went back to a board and tape or a jam chuck.
Ex[ierience is a costly teacher.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081