Turning Archive 2005

Subject:
jet mini ?

Richard H.
>My end goal is to purchase a 1640 oneway at the end of the year. However it is currently outside my budget and I need to turn some table legs.
My question is; if I purchase a Jet mini with an extension would it be adequate to turn 16" to 32" spindles with a maximum diameter of five inches.
I know i could get into a lathe with less cost but because I don't know much about them, I tend to purchase the best I can afford. My logic..? is that way I will aviod the majority of design build, fit and finish issues.
I appreciate your feedback
Thanks
Richard

Messages In This Thread

jet mini ?
Re: jet mini ?
Re: jet mini ?
Re: jet mini ?
Re: jet mini ?
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081