Turning Archive 2005

Subject:
Drive pully question

Jim Bodin
>I purchased a die cast drive pully (4 speed) from McMaster for a my Craftsman cast iron lathe. It give too much vibration (I can see the motor jumping). Where can I buy a pully that would be suitable for the lathe or should I take the die cast one to a machinest and see if it can be turned to get rid of the vibration? I'm assuming that it is out of round. If one can be purchased, where? Thanks

Messages In This Thread

Drive pully question
Re: Drive pully question
Re: Drive pully question
Re: Drive pully question
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081