Turning Archive 2005

Subject:
Four Footed Bowl *PIC*

Randy in Langley
>No not 4' but Four Feet.

Long story short, I wanted to make a bowl that hovered above the table in the middle and was supported by four feet on the exterior. My inspiration was the weel wells of the new Chrysler 300 and a bowl a fellow turner had roughed out to turn a tenon for remounting.

This bowl is from the same piece of spalted, punky figured maple slab that my last platter was from. It is 9" x 9" square, 2" high and the middle of the bowl hovers above the table by 1/4".

Comments and feedback appreciated.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081