Turning Archive 2005

Subject:
tool holder in a 5 gal bucket

Dennis Taylor
>I think it was here that I seen a pic of someone that made a tool holder from a 5 gal bucket, with holes cut in the lid for holders, can someone post that pic again, or point me toward's it..thought it was a good idea, looking for something to sit next to the lathe, so I can just pick up the tool and go...have them scattered all over now..tks in advance..Dennis

Messages In This Thread

tool holder in a 5 gal bucket
Maybe these will help
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081