Turning Archive 2005

Subject:
made a few work stands *PIC*

jim ketron
>Hello all I have been needing to make some work stands for a while and decided this weekend was the time to do it!
I have been using my lathe on a plastic table and I had a bed ex for it that has never been out of the box.
The buffing wheel has ben on my router table held on with clamps.
the grinder I have been using it on my tablesaw it has my homemade wolverine jig on it.
they were all made from 1 1/2" sch 40 pipe and 3/8"x 3" angle iron
Jim

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081