Turning Archive 2005

Subject:
dc hose is problem

Dennis Taylor (Akron, Ohio)
>I looked over the responses to my previous post, and the magnets seemed like a simple fix, I happen to have a medal hood, think from PennState for a dc hose, I think the hose is what pulls it off the lathe...I didn't glue the magnets to it, maybe that would make it better?...figure the maganets would allow it to move the length of the ways, although it is short, or level with the ways, figure it will work, not worried about the chips, but the dust...Dennis

Messages In This Thread

dc hose is problem
Re: dc hose is problem
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081