Turning Archive 2005

Subject:
dust collector/positioning

Dennis Taylor (Akron, Ohio)
>I have a small PSI dust collector with a 4in. hose attached...I just roll it to whereever it is needed, but getting the hose to attach to the lathe is my problem, I have tried to bungy cord it, tie it with wire/string, with no luck, always seems in the way...my lathe is a 1442 Jet, sitting with the back near a wall, any idea's?..I found myself not using it when sanding due to the time/trouble of trying to find a way to hold it...could I reduce from 4 to 2 and use a smaller shop vac hose?...thanks for input...dennis

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081